Chapter 4
Programming
35
Light Schedules
In this menu, a light schedule can be programmed for each unit number (1 to 8).
To program Light Schedules:
1. Enter the System Programming menu.
2. Scroll up/down to Light Control, then press Enter.
3. Scroll up/down to Light Schedules, then press Enter.
4. Scroll up/down to the desired light schedule (as defined by the unit number), then press Enter.
5. The current option value now flashes.
6. Enter the desired start time by entering the hours, minutes, and AM/PM (press Enter after
programming each part).
7. Enter the desired end time by entering the hours, minutes, and AM/PM (press Enter after
programming each part).
8. Press STATUS repeatedly to exit.
Housecode
To change the Housecode:
1. Enter the System Programming menu.
2. Scroll up/down to Light Control, then press Enter.
3. Scroll up/down to Housecode, then press Enter.
4. The current option value (A to O) now flashes.
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Lock Interval
Each light (unit numbers 1 to 8) that has been tied to a sensor can be programmed not to turn on during a
certain time of day.
To program the Lock Interval:
1. Enter the System Programming menu.
2. Scroll up/down to Light Control, then press Enter.
3. Scroll up/down to Lock Interval, then press Enter.
4. Scroll up/down to the unit number for which you want to program a lockout time, then press Enter.
5. The current option value now flashes.
6. Program the start and end times (see Light Schedules on page 35).
7. Press STATUS repeatedly to exit.
System Tests
This menu duplicates a higher-level menu. For more information, see System tests on page 28.
To Next Page
Loading...
Need help?
General
