GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 5
8-2-5 Tools needed for servicing VIVID E9 / VIVID E7
Table 8-1 Tools used for servicing VIVID E9 / VIVID E7
ITEM NO. TOOL SIZE TORQUE COMMENTS
1. BIT # TX-10 M2.5
• Use Torque specified in procedure.
• If the torque is not indicated with the
procedure, hand tighten the screws/
nuts.
• 90 degree “L“ are suggested.
• A full set of 90 degree “L“ TORX
wrenches are recommended.
2. BIT # TX-15 M3
3. BIT # TX-20 M4
4. BIT # TX-25 M5
5. BIT # TX-30 M6
6. BIT # TX-45 M10
7. FLAT BLADE SCREWDRIVER 3.2 mm
8. FLAT BLADE SCREWDRIVER 4 mm
9. FLAT BLADE SCREWDRIVER 6 mm
10. PHILLIPS SCREWDRIVER PH1
11. PHILLIPS SCREWDRIVER PH2
12. PHILLIPS SCREWDRIVER PH3
13. HEX KEY 5 mm (UNBRAKO KEY / ALLEN KEY)
14. HEX KEY 8 mm (UNBRAKO KEY / ALLEN KEY)
15. HEX KEY 10 mm (UNBRAKO KEY / ALLEN KEY)
16.
HEX KEY M12
REAR CASTERS:
130 Nm
(UNBRAKO KEY / ALLEN KEY)
REAR CASTERS
17. Nut Driver 5 mm
18. Nut Driver 3/16 inch
19. Fix wrench 8 mm
20. Fix wrench 10 mm
21.
Torque Wrench, Up to 81 Nm
(130 Nm for Rear Casters)
Heavy mechanical parts may need a
specific torque. Each procedure will
indicate the torque needed.
22.
WHEEL CHANGE KIT N/A N/A
FC200829
BEVEL EDGED BOARD
WOODEN WEDGE
To Next Page
Loading...
