GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
1 - 24 Section 1-5 - Dangerous procedure warnings
Section 1-5
Dangerous procedure warnings
Warnings, such as the example below, precede potentially dangerous procedures throughout this
manual. Instructions contained in the warnings must be followed.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING DEATH, ARE PRESENT IN
THIS EQUIPMENT. USE EXTREME CAUTION WHEN HANDLING, TESTING AND
ADJUSTING.
IF THE COVERS ARE REMOVED FROM AN OPERATING VIVID E9 / VIVID E7, SOME
METAL SURFACES MAY BE WARM ENOUGH TO POSE A POTENTIAL HEAT HAZARD
IF TOUCHED, EVEN WHILE IN SHUT DOWN MODE.
EXPLOSION WARNING
DO NOT OPERATE THE EQUIPMENT IN AN EXPLOSIVE ATMOSPHERE. OPERATION
OF ANY ELECTRICAL EQUIPMENT IN SUCH AN ENVIRONMENT CONSTITUTES A
DEFINITE SAFETY HAZARD.
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT
BECAUSE OF THE DANGER OF INTRODUCING ADDITIONAL HAZARDS, ONLY
INSTALL GE APPROVED PARTS. DO NOT
PERFORM ANY UNAUTHORIZED
MODIFICATION OF THE EQUIPMENT.
To Next Page
Loading...
