GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 15
8-4-10 Loading the software from USB Flash Drive (UFD)
8-4-10-1 Installing the System Software (only for BEP6 / BEPY3)
Follow the instructions in the table below to reload or load the software from UFD:
Table 8-5 Reloading or loading the System software from UFD, sheet 1 of 3
Step Task
1.
Check if the alphanumeric keyboard has the F11 key.
• If present, continue to the next step.
• If the keyboard does not have the F11 key (old keyboard),
connect an external keyboard with the F11 key to one of the USB
ports, and use this external keyboard during the boot.
Another workaround is to go into BIOS and select USB as the
primary boot device.
2.
Disconnect all UFDs from the USB ports on the VIVID E9 /
VIVID E7.
3.
Plug in the Software UFD in one of the USB ports on the VIVID E9
/ VIVID E7.
4.
1. Push the power on button briefly.
2. Wait until the BIOS screen appears with:
“Loading…… BIOS”
3. Then push the F11 key once.
5.
1. The Boot selection menu will now appear.
2. Select USB as boot device,
3. then press Enter.
4. The VIVID E9 will now reboot.
To Next Page
Loading...
