GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 26 Section 8-5 - Replacing Covers and Bumpers
8-5-2-3 Side Covers installation
Follow these steps to install the Side Covers:
1.) Align tabs at the top inside of Side Cover with the slots on Top Cover.
2.) Place the top edge of the Side Cover so it hooks onto the Top Cover.
3.) Align and squeeze the front edge of the side cover to latch it into place.
4.) Position the Side Cover’s side lock first.
5.) Position the Side Cover’s front lock.
6.) Align and squeeze the bottom front of the side cover to latch it into place.
7.) Position the Side Cover’s rear lock, lifting up the rear tab and guiding it into place.
8.) Align and squeeze the bottom rear of the side cover to latch it into place.
Figure 8-7 Hook the Side Cover onto Top Cover
SIDE LOCK
LOCATION
FRONT LOCK
LOCATION
To Next Page
Loading...
