GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 52 Section 8-5 - Replacing Covers and Bumpers
8-5-15-3 Main Cable Cover installation procedure
Follow these steps to install the Main Cable Cover:
1.) Install the Main Cable Cover so the Column Cover Assembly overlaps Main Cable Cover edges
(see Figure 8-26).
2.) With the console raised to its full height, install the 3 screws to secure the Main Cable Cover and
Column Cover Assembly.
3.) Lower the console and install the lower right side screw (See: Figure 8-22 "With console lowered,
lower right side screw placement" on page 8-49).
4.) Position the lower Column Cover tab inside the Front Cover.
5.) Install the Top Cover.
6.) Install the Side Covers.
Figure 8-27 Position the column cover tab inside the front cover
To Next Page
Loading...
