GE Vivid E7 - Page 401

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 85
8-6-6-2 Remove the Upper OP Panel/Touch Panel Assembly
Follow these steps to remove the Upper OP Panel/Touch Panel assembly. Ensure that the OP Panel is
in its uppermost position with the LCD out of the way:
1.) At the rear of the VIVID E9 / VIVID E7, release the console’s XY mechanism by inserting a
screwdriver into the release point and pressing until release. Pull the console out to its extended
position to gain access to the screws in the next step.
2.) Remove four screws with washers from the Operator Panel’s back cover.
Figure 8-68 Upper OP Panel//Touch Panel Assembly
Figure 8-69 XY / Frogleg mechanism release
Figure 8-70 Upper Operator Panel’s Back Cover
OPERATOR PANEL,
UPPER
XY RELEASE
FASTENING SCREWS, 2 ON EACH SIDE
(ONE SIDE ILLUSTRATED)