GE Vivid E7 - Page 417

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 101
8-6-9-2 USB Connector Board removal procedure
1.) Place the Main Controller Board on a clean, antistatic surface with the solder side up.
The USB Connector Board is plugged into the Main Controller Board.
2.) Pull the USB Connector Board upwards to disconnect it from the Main Controller Board.
8-6-9-3 USB Connector Board installation procedure
1.) Install the USB Connector Board.
2.) Install the Main Controller Board.
3.) Install the Operator Panel, Upper.
4.) Install the Control Knobs.
Figure 8-89 Main Controller Board with USB board