GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 108 Section 8-6 - Top Console Parts Replacement Overview
8-6-13-2 Options Holder removal procedure
Follow these steps to remove the Options Holder:
1.) From underneath the Upper Console, remove the 3 screws securing the Options Holder.
2.) Remove the Options Holder from the Upper Console.
8-6-13-3 Options Holder installation procedure
Follow these steps to install the Options Holder:
1.) Position the Options Holder in place.
2.) Install the 3 screws securing the Options Holder.
3.) Install the Storage Tray to the Options Holder.
8-6-14 Knobs for Encoders and Slidepots replacement
8-6-14-1 Tools
No tools are needed for this procedure.
8-6-14-2 Knobs for Encoders and Slidepots removal procedure
NOTE: If you are going to remove the Upper Operator Panel, you only need to remove the five knobs
below the Touch Screen.
1.) Pull the knobs one by one until all knobs have been removed.
2.) Store the knobs in a clean place.
Figure 8-95 Screws, beneath upper console
To Next Page
Loading...
