GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 142 Section 8-6 - Top Console Parts Replacement Overview
8-6-26-2 Remove the Speaker Assembly
Follow these steps to remove one of the Speaker Assemblies:
1.) Remove the hex key screw, fixing the Speaker Bracket to the OP frame.
2.) Disconnect the Speaker Cable from the Bulkhead board.
3.) Remove the Speaker.
4.) Repeat steps 1 - 3 for the other Speaker assembly, if necessary.
8-6-26-3 Install the Speaker Assembly
Follow these steps to install the Speakers:
1.) Position the Speaker.
2.) Install the hex key screw, fixing the Speaker Bracket to the OP frame.
NOTE: Check that the speaker bottom edge is tight or the speaker may rattle.
3.) Connect the Speaker Cable to the Bulkhead board.
4.) Repeat steps 1 - 3 for the other Speaker.
5.) Install the Operator Panel, Upper.
Figure 8-126 Speaker hex key screw
hex key screw BEHIND
RIGHT SPEAKER
To Next Page
Loading...
