GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 145
8-6-27-2 Remove the Bulkhead Board
Follow these steps to remove the Bulkhead Board:
1.) Disconnect the cables from the Bulkhead Board:
- cable from Main Cable
- cables to left and right speaker
- two short USB cables (Bulkhead Board to OP)
2.) Unscrew and remove two screws.
3.) Remove the Bulkhead Board.
8-6-27-3 Install the Bulkhead Board
Follow these steps to install the Bulkhead Board:
1.) Slide the Bulkhead Board into the correct position.
2.) Install the two screws (M3 x 6, Torque: 1.2 Nm).
3.) Install the cables from the Bulkhead Board:
- two short USB cables (Bulkhead Board to OP)
- cables to left and right speaker
- cable from Main Cable
4.) Install the Upper OP panel and the five rotary knobs.
5.) Connect probe(s) and external cables (network and mains power).
Figure 8-128 Bulkhead Board screws