GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 208 Section 8-10 - Front End Processor (FEP) / Card Cage parts replacement
8-10-2-3 FEP Cover installation procedure
NOTE: Do not use any tools when you tighten the finger screws.
1.) Install the FEP Cover and fasten it with the ten fixing screws.
Use your fingers to tighten the screws.
2.) Plug in the PCIe cable in the GFI board. The connector on the GFI card is available through the
opening in the FEP Cover.
3.) Install the EMI cover for the PCIe cable.
4.) Fasten the EMI cover for the PCIe cable with the M4 fixing screw.
5.) Install the side cover.