GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 249
8-11-4-3 Preparations - BEP5/BEP6
When preparing for the removal, or replacement, of a Graphical Adapter, you must perform the following
steps:
1.) Power down the VIVID E9 / VIVID E7.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.) Next;
- for BEP6, continue with:
8-11-4-4 "Removing the Graphics Adapter from the BEP6" on page 8-250.
To Next Page
Loading...
