GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 3 - System setup 3 - 11
5.
Remove the two Frames (sides) and the two
Exit Ramp Bases.
6.
Install the two Exit Ramp Base on the
Complete Exit Ramp (the rear plate).
7.
Remove the Support For Monitor.
Table 3-8 Uncrating the VIVID E9 / VIVID E7 (cont’d) sheet 2 of 4
Step Task Illustration