Replacement Procedures
8-26 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Rear bumper removal
Follow these steps to remove the rear bumper:
1. Remove one screw on each side of the Ultrasound system.
2. Remove the rear bumper.
Rear bumper installation
Follow these steps to install the rear bumper:
1. Place the rear bumper into position.
2. Install the 2 screws to secure the rear bumper.
Verification
Perform the following steps to verify that the product is
functioning as intended after this replacement:
1. Connect cables and probes you removed earlier
2. Power up the Ultrasound system to verify that it operates as
intended.
To Next Page
Loading...
