Casters and Brakes replacement
Vivid E80/E90/E95 – Service Manual 8-83
GC091052 Rev. 3
Brake Pedal replacement
Preparations
When preparing for the replacement, you must perform the
following steps:
1. Power down the Ultrasound system.
2. Disconnect the mains power cable from the wall outlet.
3. Disconnect all probes and external I/O cabling.
4. Remove both side covers.
5. Remove the foot rest bumper.
6. Remove the top cover.
7. Remove the front cover.
8. Remove the pedal mechanism.
Remove the Brake Pedal
The pedal is fixed to the pedal mechanism with four (4x) hex key
screws from below. Follow this procedure to remove the brake
pedal:
1. Unscrew and remove the four screws.
2. Remove the brake pedal.
Install the Brake Pedal
Follow this procedure to install the Brake Pedal:
1. Position the Brake Pedal so you can install the fixing
screws.
2. Install the four fixing screws.
Pedal Release replacement
This pedal, placed in the middle, is fixed with three screws.
With this in mind, please refer to ‘Brake Pedal replacement’ on
page 8-83 for replacement instructions.
To Next Page
Loading...
