GE Vivid E95

System Setup
3-22 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Connecting probes
Introduction to ‘Connecting probes’
The Vivid E80/E90/E95 has three types of probe ports; one PD
probe port, three PDT probe ports and one Doppler probe port.
Probes can be connected at any time, whether the Vivid E80/
E90/E95 is On or Off.
The Vivid E80/E90/E95 has three types of probe ports; one PD
probe port, three PDT probe ports and one Doppler probe port.
• The PD probe port is compatible with the Vivid 7 probe
connectors.
• The three PDT probe ports are specific to the Vivid E80/
E90/E95 probe connectors.
• The Doppler probe port is used for CW Doppler probes
(non-sector-probes), sometimes called PEDOF probes.
Figure 3-3. Probe connectors
1. PD PROBE PORT: FOR VIVID 7 COMPATIBLE PROBE
CONNECTORS
2. PDT PROBE PORT: FOR Vivid E9 SPECIFIC PROBE CONNECTORS
NOTE! The DOPPLER probe connector is not illustrated in this figure.