Geemarc 200 - Base Settings; Accessing Base Settings and Dialing Modes

22
1 - Base setting access
Each time you want access to the base setting , you will have to enter PIN code
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it
Press OK
Now you are in the base menu
2 - Tone dialing switchover
Your DECT200 has been set to tone dialing at the factory , but if your network
requires pulse dialling, you will have to change the mode
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it
Press OK
Use and to select "Dial Mode"
Press OK
Use and to choice "Pulse"
Press OK
Press twice C or once to return to standby mode
Base Setting