Geemarc 200 - Flash Time and Pause Settings

23
3 - Flash setting
Your telephone flash time is factory set for the UK ( R=100ms)
Don't change this
But sometimes if your phone is connected to a private network it might be
changed , so proceed as below :
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it
Press OK
Use and to select "Flash Time"
Press OK
Use and to choice 300 or 600ms
Press OK
Press twice C or once to return to standby mode
4 - Insert a pause
-If you need to insert a pause between the digits you dial , you can set the time of
this pause : 2,3 or 4secs
Use and to select "BS setting"
Press OK
"Base PIN" is displayed
Base Setting