918215/CP0407 28 Printed in U.S.A
INDICATORS AND CONTROLS 1448 PLUS
Travel Controls
The travel controls are used to maneuver the paver
around on the jobsite and for road travel. Decals on
the backwall top console area provide graphic
representation of the various control actions.
Hydraulic Pump Variable-Speed Control
Lever
(Item 13, Fig. 3)
This lever increases or decreases oil flow to the
drive motors. Push the lever forward to increase
speed; pull rearward to decrease speed. Place the
lever in neutral when not operating to prevent
creating excess heat in the hydraulic system.
NOTE: Lever must be all the way back
(neutral position) to start the engine.
If the paver does not completely stop traveling
when the speed control lever is in the neutral
position, adjustment is required. See “Adjusting
Variable Speed Control” on page 62.
Travel Control Levers
(Items 2 & 3, Fig. 3)
These two levers control forward, rearward and
turning travel. The travel levers are mechanically
linked together on both sides of the paver to
provide control from either side.
NOTE: Turn and/or spin the paver at slow
speeds only.
Fig. 16 - Variable-Speed Control Lever
NOTE: Variable-Speed Control Lever
Shown in Neutral Position
Fig. 17 - Travel Control
Travel Type Lever Position
Forward Both levers forward
Reverse Both levers back
Stop both levers returned to
neutral
Left Turn Right lever forward
Right Turn Left lever forward
Spin (paver spins
around its center)
Right/left levers in opposite
directions
Fig. 18 - Travel Controls
Courtesy of Machine.Market
To Next Page
Loading...
