Printed in U.S.A 63 918215/CP0407
1448 PLUS SERVICE AND STORAGE
4. Apply grease to all exposed hydraulic cylinder
rod areas.
5. Add stabilizer to fuel per fuel supplier's
recommendation.
6. Disconnect the battery cable clamps and cover
or remove the battery from the paver and store
it separately.
7. If the ambient temperature (at any time during
the storage period) is expected to drop below
freezing, make sure that the engine coolant is
either completely drained from the radiator and
engine block or that the amount of anti-freeze
in it is adequate to keep the coolant from
freezing. Refer to the engine operator’s manual
for anti-freeze recommendations and
quantities.
During Storage
1. Once each month, connect the battery and
check all fluid levels to make sure that they are
at the proper level before starting the engine.
2. Start the engine, run it until it warms up, and
then move the machine a short distance to help
lubricate the internal parts.
3. Run the engine until the battery charges and
then shut it off.
IMPORTANT: If operating the hydraulic
cylinders, wipe the protective grease and any
dirt from the hydraulic cylinder rods before
starting the engine.
After Storage
After removing the paver from storage and before
operating it, perform the following:
1. Refer to the engine manual for proper engine
operation procedures following storage.
2. Change the engine oil and filter to remove
condensation and any other contamination.
3. Wipe off grease off the hydraulic cylinder rods.
4. Lubricate all grease fittings.
5. Read the Safety chapter, page 15.
6. Follow start and warm-up procedures.
(See “Operation” chapter, page 37).
Courtesy of Machine.Market
To Next Page
Loading...
