EasyManua.ls Logo

Gehl 1448 Plus - Decal Locations; General Information and Paint Notice; New Decal Application

Gehl 1448 Plus
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Printed in U.S.A 73 918215/CP0407
Chapter 12
DECAL LOCATIONS
GENERAL INFORMATION
Decal location information is provided to assist in
the proper selection and application of new decals,
in the event the original decals become damaged or
the machine is repainted. Refer to the listing for the
illustration reference number, part number,
description and quantity of each decal provided in
the kit. Refer to the illustrations for appropriate
replacement locations.
To ensure proper selection of the correct replace-
ment decals, compare all of the various close-up
location drawings to the machine before starting to
refinish the unit. Then circle each decal shown
(applicable to the machine) while checking off its
part number in the listing. After verifying all the
decals needed for replacement, place any extra
unnecessary decals aside for disposal. If there is a
decal on a part that is to be replaced, be sure that
the replacement part has the decal applied to it.
NOTE: Refer to the SAFETY chapter of this
Operator's Manual for the specific information
provided on the various safety decals
furnished in the decal kit.
NEW DECAL APPLICATION
Surfaces MUST be free from dirt, dust, grease and
other foreign material before applying the new
decal. To apply, remove the smaller portion of the
decal backing paper and apply this part of the
exposed adhesive backing to the clean surface
while maintaining proper position and alignment.
Slowly peel off the other portion of the backing
paper while applying hand pressure to smooth out
the decal surface.
CAUTION
ALWAYS follow safety precautions on decals.
Replace the decals if they are damaged, or if
the unit is repainted. If repainting, BE SURE all
applicable decals are affixed to the unit.
The decal kit for the model 1448 Plus Paver is
listed below:
PAINT NOTICE
Use this list to order paint for refinishing:
167788 4 qts. Construction Yellow (GEHL)
167758 4 qts. Charcoal Gray (GEHL)
167789 6 (12.8 oz. Spray Cans) Yellow (GEHL)
167760
6 (12.8 oz. Spray Cans) Charcoal Gray (GEHL)
Ref.
No.
Part
No.
Description & Quantity
176060 Decal Kit - 1448 Plus
1
072798 WARNING - Coolant Under Pressure
2
137628 WARNING - Avoid Injury or Death
3
175862 Maintenance Chart
4
P204100 WARNING - Read Manual
5
P204015 Pump Variable Speed Control
6
P204012 Left Side Control Levers
7
P204013 Right Side Control Levers
8
P201400 Indicator (2 Places)
9
L65942 WARNING - Hot Surface
10
L65927 WARNING - Pinch Point (5 Places)
11
L65924 DANGER - Rotating Components
12
P471840 Exhaust Diverter
13
P471816 Asphalt Release
14
P214000 Up-Down (2 Places)
15
P212750 Drive Control
16
P210200 Safety Prop (2 Places)
17
P204107 Horn (2 Places)
18
P204101 WARNING - Tip-Over Hazard
19
175981 Pressure Test Points
20
175805 Filter Reference
21
137632 Hydraulic Oil
22
137634 Diesel Fuel
23
140516 Flag
24
101481 Power Box (2 Places)
25
175899 1448 Plus/Right
175933 1448 Plus//Left
26
183963 GEHL 3.75 X 15.92 (2 Places)
Courtesy of Machine.Market

Table of Contents

Related product manuals