Gemmy PLC-012E - Operation; Safety Warning During Operation

OPERATION：
：：
：
- Refer to the specification label located on back of this equipment.
- Plug cord in a properly grounded outlet.
- Place the test tubes into the tube holders. Be sure to place tubes
systemically and diagonally to keep the rotor balance.
- Close the lid completely and press the locking latch on side of this
equipment.
- Switch power to ON position, preset time to your desired setting.
- Regulate the speed by turning the control knob of speed to your
desired speed.
- PLC-012E and PLC-024 are equipped with a 3-digit LED digital
speed indicator with a step of 100 rpm. Once the desired time is
set, press “START” button to drive the motor, and regulate the
speed by turning the control knob of speed regulation to your
desired speed setting.
- The high torque motor accelerates to the maximum speed in 15-20
seconds both for power 110V/60Hz and 220V/50Hz.
- When the time has elapsed, the power will shout out automatically.
Press the toggle switch to brake to the complete stop within 15 –
20 seconds. Switch off power immediately in order to avoid the
reverse rotation.
- A power shutout safety device is mounted to shut out the power
automatically when open the lid during the spinning.
- Press the locking button located on the up-right hand of this
equipment to unlock the cover.
- Remove the testing specimens carefully from the rotor.
WARNING：（
：（：（
：（IMPORTANT）
））
）
- Do not open the lid only until the rotor is stopped completely.
There is possibility on person injury if you violate this regulation.
Gemmy will not ensure any responsibility if you violate this
regulation.
- A safety lid locking device is functioned to shut off power when
open the lid during operation.
5