Installation Steps
25
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
Final Steps to Install Master Control
Leveling Plate Screw
Lower Mounting Bolt
1. Loosen the screw that secures the leveling plate at the bottom mounting
location. Center the plate in its range of movement. Start the lower
mounting bolt.
Figure 13 Loosen the Screw Securing the Leveling Plate
and Start the Lower Mounting Bolt
2. Verify the level and plumb of the Master Control. Tighten (do not over
tighten) the leveling plate screw to lock the level of the unit
Figure 14 Level and Plumb the Master Control
3. Tighten both mounting bolts.
Note! Alternate mounting holes are located at the top of the Master Control for
additional stability for the unit.
To Next Page
Loading...
