Configure Exposure Settings
48
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
Configure Exposure Settings
Refer to the User Manual for instructions on how to use the Master Control
Touch Panel to change the default settings for a different film speed or
digital imaging system. Also refer to the User Manual for complete
information concerning customized anatomical exposure settings
The default settings for anatomical exposure times are set at the factory
according to the standard configuration: D-speed film or DenOptix imaging
and an 8" (20 cm) focal length cone.
To change the default settings from an 8" (20 cm) focal length cone to a 12"
(30 cm) cone, refer to the procedure provided in the Service Manual.
To Next Page
Loading...
