What to do if Generac Power Systems 0064390 has no AC output?
If there is no AC output from your Generac Power Systems Inverter, check if the main line circuit breaker is in the OFF (or OPEN) position. If so, reset the circuit breaker to ON (or CLOSED). It could also be a generator internal failure.
Why Generac Power Systems 0064390 engine will not crank?
If the engine of your Generac Power Systems Inverter won't crank, it could be due to several reasons: * A blown fuse: Correct the short circuit condition by replacing the 7.5 Amp fuse in the generator control panel. * Loose, corroded, or defective battery cables: Tighten, clean, or replace the cables as necessary. * A dead battery: Charge or replace the battery.
What to do if Generac Power Systems Inverter unit consumes large amounts of oil?
If your Generac Power Systems Inverter consumes large amounts of oil: * Ensure the engine isn't overfilled with oil; adjust to the proper level. * Check for damaged gaskets, seals, or hoses that may be causing oil leaks. * Make sure you are using the recommended type and viscosity of oil.
Why Generac Power Systems 0064390 Inverter engine cranks but will not start?
If your Generac Power Systems Inverter's engine cranks but doesn't start, possible causes include: * Being out of fuel: Replenish the fuel and turn on the fuel valve. * Defective spark plugs: Clean, re-gap, or replace the spark plug(s). * Valve lash out of adjustment: Reset the valve lash.
How to fix Generac Power Systems 0064390 Inverter engine that starts hard and runs rough?
If your Generac Power Systems Inverter engine starts hard and runs roughly, consider the following: * Check and replace the air cleaner if it is plugged or damaged. * Clean, re-gap, or replace defective spark plug(s). * Confirm fuel pressure to the regulator is 10-12” water column (19-22mm mercury) for LP, and 3.5 - 7” water column (9-13mm mercury) for natural gas. * Turn the fuel conversion valve to the correct position, if the fuel selector is in the wrong position.
Covers manual reading, safety warnings, and how to obtain service for the generator unit.
Details general, exhaust, electrical, fire, and explosion hazards with necessary precautions.
Outlines general rules, NEC requirements, and applicable industry standards for installation.
Lists required tools and general steps for unpacking the generator set.
Instructions for inspecting for shipping damage and identifying loose parts.
Specifies site selection criteria, clearance, and installation guidelines from standards.
Covers site preparation, base requirements, and recommendations for transporting the generator.
Details the required placement and leveling of the generator unit on its pad.
Instructions for installing the optional fascia base wrap for aesthetic and protective purposes.
Covers fuel requirements, consumption rates, and sizing for natural gas and propane lines.
Provides steps for fuel conversion, installing gas lines, shutoff valves, and checking connections.
Details connecting the generator to the transfer switch and control wiring procedures.
Explains main AC wiring, battery requirements, and the procedure for battery installation.
Covers control panel interface, activation, cold smart start, exercise timer, and installation wizard.
Details manual transfer switch operation, electrical checks, load tests, and automatic operation verification.
Provides a guide to diagnose common generator problems and their potential causes and solutions.
A quick guide to system diagnosis, LED indicators, problems, and corresponding solutions.
Diagrams illustrating the interconnection of the generator, transfer switch, and control panel.
Dimensional drawings showing the generator, transfer switch, and mounting hole locations.
General| Model Number | 0064390 |
|---|---|
| Category | Inverter |
| Brand | Generac Power Systems |
| AC Voltage | 120V |
| Voltage | 120 V |
| Frequency | 60 Hz |
| Fuel Type | Gasoline |
| Engine Displacement | 79 cc |
| Warranty | 3 Years Limited |
| Engine Type | OHV |
| Outlets | 120V 20A |
To Next Page