Generac Power Systems 15 kW EcoGen - Installation Drawing (2 of 2)

Diagrams
46 Installation Guidelines for 60 Hz EcoGen™ Generator
Installation Drawing (2 of 2)
914 [36.0]914 [36.0]
MINIMUM OPEN AREAMINIMUM OPEN AREA
ON SIDES AND FRONTON SIDES AND FRONT
457.2457.2
[18.0][18.0]
560.0560.0
[22.0][22.0]
353.7353.7
[13.9][13.9]
1154.01154.0
[45.4][45.4]
446.6446.6
[17.6][17.6]
389.7389.7
[15.3][15.3]
36.036.0
[1.4][1.4]
44.844.8
[1.8][1.8]
300.4300.4
[11.8][11.8]
179.0179.0
[7.0][7.0]
REAR VIEWREAR VIEW
**ALL DIMENSIONS IN:**ALL DIMENSIONS IN:
MILLIMETERS [INCHES] MILLIMETERS [INCHES]
A CONCRETE PADA CONCRETE PAD
OPTIONAL MOUNTING TOOPTIONAL MOUNTING TO
HOLE LOCATIONS FORHOLE LOCATIONS FOR
TOP VIEWTOP VIEW
16.0 [5/8] DIA. CLEARANCE16.0 [5/8] DIA. CLEARANCE
HOLE (2) PLACES,HOLE (2) PLACES,
3/8 DIA. MASONRY ANCHOR3/8 DIA. MASONRY ANCHOR
BOLTS RECOMMENDEDBOLTS RECOMMENDED
AIR INTAKEAIR INTAKE
AIR OUTLETAIR OUTLET
AIR INTAKEAIR INTAKE
MAIN AC/CONTROL WIRING HOLE FOR 3/4" CONDUITMAIN AC/CONTROL WIRING HOLE FOR 3/4" CONDUIT
RIGHT SIDE VIEWRIGHT SIDE VIEW
FRONT OF UNITFRONT OF UNIT
10.0 [3/8] DIA. CLEARANCE10.0 [3/8] DIA. CLEARANCE
HOLE (2) PLACES,HOLE (2) PLACES,
3/8 DIA. MASONRY ANCHOR3/8 DIA. MASONRY ANCHOR
BOLTS RECOMMENDEDBOLTS RECOMMENDED
A CONCRETE PADA CONCRETE PAD
OPTIONAL MOUNTING TOOPTIONAL MOUNTING TO
HOLE LOCATIONS FORHOLE LOCATIONS FOR
FUEL INLET - 3/4" NPT FUEL INLET - 3/4" NPT
REQUIRED FUEL
PRESSURE: NATURAL GAS : 3.5-7" WATER COLUMNREQUIRED FUEL PRESSURE: NATURAL GAS : 3.5-7" WATER COLUMN
LIQUID PROPANE (VAPOR) : 10-12" WATER COLUMN LIQUID PROPANE (VAPOR) : 10-12" WATER COLUMN
MAIN AC/CONTROL WIRING HOLE FOR 1 1/4" CONDUITMAIN AC/CONTROL WIRING HOLE FOR 1 1/4" CONDUIT
001476b