Section 6 - Appendix
Air-cooJedGenerators
6.1 MENU SYSTEM NAViGATiON
To get to the MENU, use the "Esc" key from any
page. It may need to be pressed many times before
getting to the menu page. The currently selected
menu is displayed as a flashing word. Navigate to
the menu required by using the +/- keys. When the
menu required is flashing, press the ENTER key.
Depending on the menu selected, there may be a
list of choices presented. Use the same navigation
method to select the the desired screen (refer to the
Menu System diagram).
• 6.1.1 CHANGING SETTINGS {EDIT MENU)
To change a setting such as display contrast, go to the
EDIT menu and use the +/- keys to navigate to the
setting to change. Once this setting is displayed (e.g.
Contrast), press the ENTER key to go into the edit
mode. Use the +/- keys to change the setting, press
the ENTER key to store the new setting.
NOTE:
If the ENTER key is not pressed to save the new
setting, it will only be saved temporarily. The next
time the battery is disconnected, the setting will
revert back to the old setting.
3O
To Next Page
Loading...
Need help?
General
