General Dynamics DIGITAL TRACKING RECEIVER - Page 117

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
56
LIST-FAULTS
Path: Keyword
Type: Executable
Syntax: LIST-FAULTS
Notes: Lists all fault names along with their LCD text names, and their current status. This
report is in verbose ASCII format, for readability. For periodic status polling, us the
F keyword (HEX bitmapped fault report).
For example:
Fault Name Text Name Current Status
LOW-INPUT-SIGNAL Low Input Signal Set Not Acknowledged
INPUT-SIGNAL-SATURATED Input Saturated Cleared
MCU-LINKLOSS MCU Link loss Set Not Acknowledged
DSP-LINKLOSS DSP Link loss Set Not Acknowledged
DSP-DATALOSS DSP Data loss Set Not Acknowledged
SPU-RESPONSE-OVERFLOW SPU Overflow Cleared
TBT-LINKLOSS TBT Link loss Cleared
TBT-FAULT TBT Summary Fault Cleared
TBT-IN-LOCAL TBT in Local Ctrl Cleared
OUT-OF-BAND Out of Band Cleared
INVALID-BAND-SETUP Invalid Band Setup Cleared
BDC1-FAULT Band 1 BDC fault Cleared
BDC2-FAULT Band 2 BDC fault Set Not Acknowledged
BDC3-FAULT Band 3 BDC fault Cleared
BDC4-FAULT Band 4 BDC fault Cleared
PLL1-UNLOCKED PLL1 Unlocked Cleared
PLL2-UNLOCKED PLL2 Unlocked Cleared
FACTORY-BURN-IN Factory Burn In Cleared
NVRAM-CORRUPTED NVRAM corrupted Cleared
FAULTY-MUTE-SWITCH Mute Switch Fault Cleared
SPU-LINK-LOCKED SPU Link locked Cleared
LS
Path: Keyword
Type: Executable
Syntax: LS
Notes: Keywords are not listed. Use KEYS to see the keyword list.
LS (Lists) lists all items in the current menu in the form "n" type “title” [ = value].
Where n = item’s menu index [0, (# of items in menu) –1]. Type = ‘X’
(executable), ‘M’ (menu), ‘E’ (editable). If ‘E’, then value is also printed with ‘=’
between item title and value. Note: keywords are not listed. Use KEYS to see the
keyword list.