Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
20
DETECTION TYPE (Only in Wideband Units)
Path: / CONFIGS OPERATION DETECTION
Type: Data Editor
Syntax: DETECTION [= n] | [D]
Range: Integer: 0 .. 3
0 FFT SIGNAL 2 RMS POWER
1 FFT NOISE 3 RMS DENSITY
Notes: DETECTION selects how the DTR will report signal power. FFT SIGNAL is the
default, used to track broad spectrum signals, using FFTs. FFT NOISE is a special
mode used to track broad spectrum signals, using FFTs. RMS POWER will report a
direct RMS power estimate, without using FFTs. RMS DENSITY will report direct
RMS power density estimate, without using FFTs.
DIAGS (v1.13 or earlier)
Notes: This menu’s name changed to STATUS after v1.13.
DISPLAY TIME DOMAIN
Path: / TESTS TIME-DOMAIN
Type: Executable
Syntax: TIME-DOMAIN
Notes: Provides a display of the sampled waveform, in time domain, of the received signal.
DISPLAY VERSION
Path: / STATUS VERSION
Type: Executable
Syntax: VERSION
Notes: DISPLAY VERSION displays firmware versions and configuration information (P/N,
S/N, Release date, and configuration in hexadecimal).
To Next Page
Loading...