Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
19
DAC2 OUTPUT
Path: / CONFIGS OPERATION ANALOG-OUTPUTS DAC2 DAC2-OUTPUT
Type: Sub Menu
Syntax: DAC2-OUTPUT
Range: Integer: 0 .. 1
0 Disabled
1 Enabled.
Notes: Enables or Disables this DAC output.
DAC1 SETUP
Path: / CONFIGS OPERATION ANALOG-OUTPUTS DAC1
Type: Sub Menu
Syntax: DAC1
Notes: Allows setup of DAC1 which provides an analog DC voltage proportional to signal
level on pins 1 and 14 (+OUT, -OUT) of I/O Interface #1 on the back panel.
DAC2 SETUP
Path: / CONFIGS OPERATION ANALOG-OUTPUTS DAC2
Type: Sub Menu
Syntax: DAC2
Notes: Allows setup of DAC2 which provides an analog DC voltage proportional to signal
level on pins 3 and 16 (+AUX , -AUX) of I/O Interface #1 on the back panel.
To Next Page
Loading...