Operation
4-16
CG-1220 DTR
4.2.5.6 SYSTEM MEMORY
The SYSTEM MEMORY menu contains functions related to the storage of system
parameters in nonvolatile RAM (NVRAM).
FACTORY CALIBRATION contains system parameters that are calibrated in
factory and are NOT normally changed by the user. CHANGING THE
PARAMETERS IN THIS MENU MAY DEGRADE THE PERFORMANCE OF THE
DTR.
SAMPLING FREQUENCY compensates for the oscillator's slight deviation
from nominal 64 MHz. Entering the actual oscillator frequency to within
1Hz maximizes the receiver's performance. This calibration is done in the
factory for each DTR before shipment; it should NOT be changed in most
cases.
If it must be reconfigured, connect a cable from the 70 MHz IF monitor
(on the front of the DTR) to a spectrum analyzer. Set up the spectrum
analyzer as follows:
1) Set Auto Couple to ALL. 5) Center the frequency.
2) Set Frequency to 64 MHz. 6) Span down to 500 Hz.
3) Set Span to 5 KHz. 7) Record and enter the measured value.
4) Peak-search the signal.
NCO OFFSET adjusts the frequency of the Numerically Controlled
Oscillator (NCO) on the SPU.
POWER LEVEL CALIBRATION adjusts the calibration value used to
calculate the signal power measurement reported by the DTR (shown on
the front display in dBm). This parameter should NOT be modified under
normal circumstances.
MANUAL IF OVERRIDE allows the user to manually select the
Intermediate Frequency (IF) used by the L-band front end. The DTR
normally selects the optimal IF; this menu provides flexibility for special
cases.
FREQUENCY #1-4 OVERRIDE allows user selection of up to four IF1s
used by the L-band front end for current frequency. IF1 specifies an
approximate center for the digital filter within a 25 MHz analog filter
centered at 836.5 MHz. “Automatic” is the default setting, but
settings from 824.8 to 847.2 MHz are available.
HARDWARE OPTIONS allows factory setup of special hardware
configurations. These options are typically set in the factory and should
not be changed under normal circumstances.
POL INPUTS allows user selection of STANDARD or MULTI PORT.
To Next Page
Loading...