General Dynamics DIGITAL TRACKING RECEIVER - 4 Dtr Menu Tree with M&C Commands

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
10
4.0 DTR MENU TREE WITH M&C COMMANDS
The DTR listing shows all of the menu items, user editable parameters and executable commands.
The listing also shows the M&C command that is equal to the menu item. Only the MAIN MENU
items are shown in bold letters while all of the OPTIONAL items or menus that contain optional
features and choices are italicized. All menu items with submenus or parameters below them are
followed by three trailing periods…
DTR MAIN MENU SYSTEM
MAIN MENU TYPE PARENT MENU
FREQUENCY Data Editor MAIN MENU
INPUT-ATTEN Data Editor MAIN MENU
POL-SELECT Data Editor MAIN MENU
STATUS … Sub Menu MAIN MENU
SPECTRAL-DISPLAY Executable STATUS
SPU-DIAG (“SPU SERIAL LINK STATS”) Executable STATUS
I/O-STATUS Executable STATUS
FIFO-STATUS Executable STATUS
LOG (“MESSAGE LOG”) Executable STATUS
VERSION (“DISPLAY VERSION”) Executable STATUS
TASKS or TASKS-DIAG (“CPU TASKS”) Executable STATUS
TROUBLESHOOT Executable STATUS
CONFIGS… Sub Menu MAIN MENU
COMM-PARAM (“COMM PARAMETERS”)… Sub-Menu CONFIGS
REM-CONTROL (“REMOTE CONTROL”) Data Editor COMM-PARAM
PORT-1… Sub Menu COMM-PARAM
BPS (“BPS (BAUD)”) Data Editor PORT-1
NEWLINE Data Editor PORT-1
ECHO Data Editor PORT-1
SHELL Data Editor PORT-1
RESET-PORT Executable PORT-1
PORT-2… Sub Menu COMM-PARAM
BPS (“BPS (BAUD)”) Data Editor PORT-2
NEWLINE Data Editor PORT-2
ECHO Data Editor PORT-2
SHELL Data Editor PORT-2
RESET-PORT Executable PORT-2
PORT-3… Sub Menu COMM-PARAM
BPS (“BPS (BAUD)”) Data Editor PORT-3
SHELL Data Editor PORT-3
MASTER-ADDRESS Data Editor PORT-3
SLAVE-ADDRESS Data Editor PORT-3
ADDRESS-OFFSET Data Editor PORT-3
RESET-PORT Executable PORT-3
OPERATION (“RECEIVER OPERATION”)… Sub Menu CONFIGS
FILTER Data Editor OPERATION
ANALOG-OUTPUTS… Sub Menu OPERATION
DAC1 (“DAC1 SETUP”) Sub Menu ANALOG-OUTPUTS
DAC1-RANGE (“VOLT RANGE”) Data Editor DAC1
DAC1-REF (“MIN REF PWR LVL”) Data Editor DAC1
DAC1-SLOPE (“SLOPE”) Data Editor DAC1
DAC1-OUTPUT (“OUTPUT”) Data Editor DAC1
DAC2 (“DAC2 SETUP”) Sub Menu ANALOG-OUTPUTS
DAC2-RANGE (“VOLT RANGE”) Data Editor DAC2
DAC2-REF (“MIN REF PWR LVL”) Data Editor DAC2
DAC2-SLOPE (“SLOPE”) Data Editor DAC2
DAC2-OUTPUT (“OUTPUT”) Data Editor DAC2
UPDATE (“UPDATE RATE”) Data Editor ANALOG-OUTPUTS
ATTENUATION Data Editor ANALOG-OUTPUTS
AVERAGING (“FFT SAMPLE AVERAGING”) Data Editor OPERATION
DETECTION (only in Wideband units) Data Editor OPERATION