Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
24
FORCE CLEAR FAULTS
Path: / CONFIGS MEMORY CLEAR-FAULTS
Type: Executable
Syntax: CLEAR-FAULTS
Notes: FORCE CLEAR FAULTS forces the system to clear all faults, Faults that are set
periodically will appear again.
FREQ #1 IF OVERRIDE
Path: / CONFIGS MEMORY CALIBRATION IF-OVERRIDE F1-OVERRIDE
Type: Data Editor
Syntax: F1OVERRIDE [= n] | [D]
Range Integer: 0 .. 15
0 – Automatic 4 – 829.6 8 – 836.0 12 – 842.4
1 – 824.8 5 – 831.2 9 – 837.6 13 – 844.0
2 – 826.4 6 – 832.8 10 – 839.2 14 – 845.6
3 – 828.0 7 – 834.4 11 – 840.8 15 – 847.2
Notes: Allows user selection of IF1 used by the L-Band front end for the current frequency.
IF1 specifies an approximate center for the digital filter within a 25MHz analog filter
centered at 836.5.
FREQ #2 IF OVERRIDE
Path: / CONFIGS MEMORY CALIBRATION IF-OVERRIDE F2-OVERRIDE
Type: Data Editor
Syntax: F2OVERRIDE [= n] | [D]
Range: Integer: 0 .. 15
0 – Automatic 4 – 829.6 8 – 836.0 12 – 842.4
1 – 824.8 5 – 831.2 9 – 837.6 13 – 844.0
2 – 826.4 6 – 832.8 10 – 839.2 14 – 845.6
3 – 828.0 7 – 834.4 11 – 840.8
15 – 847.2
Notes: Allows user selection of IF1 used by the L-Band front end for the current frequency.
IF1 specifies an approximate center for the digital filter within a 25MHz analog filter
centered at 836.5.
To Next Page
Loading...