Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
31
LOW FREQ (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-4 LOW-FREQ
Type: Data Editor
Syntax: LOW-FREQ [= n] | [D]
Range: Real: 945.000 .. 13000.000 (v2.0.7 or later)
Real: 949.000 .. 13000.000 (v2.0.4 or earlier)
Notes: LOW end FREQUENCY of the BDC that supports this band. Typical configurations:
S-band = 2000MHz
C-band = 3400MHz
X-band = 7250MHz
Ku-lo-band = 10700MHz
Ku-hi-band = 11700MHz
Ka-A = 17000, Ka-B = 18100, Ka-C = 19200, Ka-D = 20200, Ka-E = 21200
LOW SIGNAL LEVEL
Path: / CONFIGS UI-OPTIONS LOW-SIGNAL-LEVEL
Type: Data Editor
Syntax: LOW-SIGNAL-LEVEL [= n] | [D]
Range: Real: -199.00 .. -1.00
Notes: This value, in dB, is used to trigger the low input signal fault.
LOW SIGNAL ALARM
Path: / CONFIGS UI-OPTIONS LOW-SIGNAL-ALARM
Type: Data Editor
Syntax: LOW-SIGNAL-ALARM [= n]
Range: 0 (“disabled”)…1 (“enabled”)
Notes: Enables the Low Input Signal alarm, allowing the fault to be reported. This is not
useful for most applications and is disabled by default.
To Next Page
Loading...