Genesis Scuba CENTAURI - Page 28

27
Free Diving Surface Interval Alarm
To access: From SETTINGS, press the UP or DOWN
buttons until the pointer aligns with FDPTH-ALM.
Press the MODE button once.
To change values: When you see a blinking option
at the bottom of the screen, use UP or DOWN
buttons to select a different option, then press the
MODE button to confirm and finish the settings.
If you set the FSI-ALM on, when you reach the
preset surface interval, the alarm will activate.
FSI-ALM,
F: Free Dive
SI: Surface Interval
ALM: Alarm.
Free Dive Time Alarm Setting
To access: From SETTINGS, press the UP or DOWN
buttons until the pointer aligns with FTIME-MAX1.
Press the MODE button once.
To change values: When you see a blinking option
at the bottom of the screen, use UP or DOWN
buttons to select a different option, then press the
MODE button to confirm and finish the settings.
If you reach the FTIME-MAX1 - Time, the alarm will
activate. There are 3 alarm setting options: 30s, 60s
& 90s.
FTIME-MAX1
F: Free Dive
TIME: Dive Time
MAX1: Maximum preset value at which the alarm
will activate.