Genesis 11C - Communication Module and Radio Connection

29 WWW.GENESISRESCUE.COM
4.7 Communication Module and Radio Connection
The communication module is installed in the rear housing component. This transmits data
from the tool to an external output device via WLAN or an LTE connection - depending on the
user's choice and the active operating mode. The basic hydraulic functions are always
guaranteed by component separation.
To use the SLi features and for registration, follow the instructions in Chapter 4.9.
i
NOTE!
The range of the radio cnnection can be inuenced by environmental
factors and is therefore dependent on many aspects such as weather,
buildings, vegetation, terrain, etc. Underwater radio communication is
not possible!
4.7.1 Standards and Data Sheets
Conrmed standards concerning electromagnetic compatibility:
EN IEC61000-6-1:2019
EN IEC61000-6-2:2019
EN IEC61000-6-3:2006 + A1:2010
EN IEC61000-6-4:2019
ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
ETSI EN 301 489-19 V2.1.1
ETSI EN 301 489-52 V1.1.0
Conrmed standards concerning radio communication:
ETSI EN 301 511 V12.5.1 (2017-03)
ETSI EN 301 908-1 V13.1.1 (2019-1)
ETSI EN 300 328 V2.2.2 (2019-07)
ETSI EN 301 893 V2.1.1 (2017-05)
ETSI EN 303 413 V1.1.1 (2017-06)
4.7.2 Information Regarding Radio Channels Used
GNSS: Ae1, Ae2, L1
WIFI Range/Frequencies: 3b
Frequency Range: 2400Mhz-2483.5Mhz, 5150Mhz-5350Mhz, 5470Mhz-5725Mhz
Channel Width: Broadband
Number of RF Channels: WIFI 2.4GHz: 13, WIFI 5GHz: 9
4G Range: B1 (2100), B2 (1900), B3 (1800), B4 (AWS 1700), B5 (850), B8 (900), B12 (700), B13 (700), B18 (800), B19
(800), B20 (800), B26 (850)
2G Range:B2 (1900), B3 (1800), B5 (850), B8 (900)
"uncontrolled if printed"