49 WWW.GENESISRESCUE.COM
9 Maintenance
9.1 Safety Instruction
WARNING!
Danger of injury due to defective maintenance work!
Improper operation of the tool can cause severe injury or property damage.
Therefore, it is absolutely necessary to:
• Have all maintenance work carried out by trained specialists.
• Ensure good housekeeping and cleanliness at the workplace! Loose
components and tools left lying around constitute a potential hazard.
• Wear protective gloves during all work!
9.2 Upkeep and Maintenance
To be ready for operation at any time, the following measures are absolutely imperative:
• After every load, but at least once a year, visually check the tool and its accessory parts.
At this time, pay particular attention to spreader tips, blades, housing and seal on the
battery cover.
• Every three years, or whenever a doubt is raised about the safety or reliability of the
tool, a function and load test must also be carried out (per DGUV guideline 305-002 or
country-specic regulations).
• After every load, check the lubrication of the movable parts and pins, and spray with suitable
grease if necessary. Special attention should be paid to lubrication via the lubrication groove
provided for this purpose on the spreaders, as well as the grease nipple on the cutters.
• Every 10 years we recommend a complete change of the hydraulic oil by our factory service
to maintain full performance.
"uncontrolled if printed"
To Next Page
Loading...
