42 WWW.GENESISRESCUE.COM
6.3 Intended Use
The charger listed in the table is approved for charging the 18V Li-Ion batteries of the M18/V18
system supplied with the battery tool.
6.4 Mains Connection
Only connect to single-phase alternating current and only to the mains voltage specied on
the rating plate. It can also be connected to sockets without an earth contact as it is built in
accordance with protection category II.
6.5 Li-Ion Battery
For safety reasons, the batteries are discharged when they are delivered (air transport
regulation). The battery must be charged completely before rst use.
LED Charing Status Indication
If the battery is not used for a longer period of time, it switches to idle mode. The battery must
be re-activated (charged) in order to be used again.
The charging status can be checked by pressing the button on the battery. The battery can
remain in the charger for this but the charger must be switched off at least 1 minute before
(otherwise the indication will be inaccurate). The number of glowing LEDs indicates the charge
status.
As a matter of principle, the following applies: if the battery tool does not work after inserting
the battery, plug the battery into the charger to check it. The indications on the battery and the
charger then provide information on the battery condition.
You can continue to work with reduced power at lower temperatures. For best operational
readiness, the batteries must be fully charged after use. The batteries have special protection
against deep discharge.
BATTERY AND CHARGER
"uncontrolled if printed"
To Next Page
Loading...
