3-33
03
Rear center seatbelt
(3-point rear center seat belt)
ORS031048 ORS031048
1. Take out the buckle, which is stored
between the seat/seatback cushions.
2. Insert the metal plate (1) into the
buckle, until it clicks. You can make
sure its secure fastening by pulling
the seatbelt webbing. The buckle with
‘CENTER’ mark should be used for the
3-point seatbelt.
3. Restore the buckle between the seat/
seatback cushion after unfastening
the seatbelt.
Information
If you are not able to pull out the safety
belt from the retractor, firmly pull the belt
out and release it. After release, you will be
able to pull the belt out smoothly.
WARNING
Make sure that the seatback is locked in
place when using the rear center seat
belt.
If not, the seatback may move when
there is a sudden stop or collision,
which could result in serious injury.
Pre-tensioner seat belt
OJKEV031078OJKEV031078
Your vehicle is equipped with driver’s and
front passenger’s and rear passengers
Pre-tensioner Seat Belts (Retractor
Pre-tensioner). The purpose of the pre-
tensioner is to make sure the seat belts
fit tightly against the occupant’s body
in certain frontal or side collision(s).
The pre-tensioner seat belts may be
activated in crashes where the frontal
or side collision(s) is severe enough,
together with the air bags.
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position.
In certain frontal collisions, the pre-
tensioner will activate and pull the seat
belt into tighter contact against the
occupant’s body.
If the system senses excessive tension
on the driver or passenger’s seat belt
when the pre-tensioner system activates,
the load limiter inside the retractor
pre-tensioner will release some of the
pressure on the affected seat belt (if
equipped with load limiter).
To Next Page
Loading...
