Genesis Electrified GV70 - High Beam Assist Malfunction and Limitations

5-79
05
High Beam Assist malfunction
and limitations
High Beam Assist malfunction
OJKEV052247LOJKEV052247L
When High Beam Assist is not working
properly, the ‘Check High Beam Assist
(HBA) system’ (or ‘Check HBA (High
Beam Assist) system) warning message
will appear and
warning light will
illuminate on the cluster. We recommend
that the function be inspected by an
authorized retailer of Genesis Branded
products.
Limitations of High Beam Assist
High Beam Assist may not work properly
in the following situations:
• Light from a oncoming or front vehicle
is not detected because of lamp
damage, or because it is hidden from
sight, etc.
• Headlamp of a oncoming or front
vehicle is covered with dust, snow or
water.
• A front vehicle’s headlamps are off but
the fog lamps are on, etc.
• There is a lamp that has a similar
shape as a vehicle’s lamp.
• Headlamps have been damaged or
not repaired properly.
• Headlamps are not aimed properly.
• Driving on a narrow curved road,
rough road, uphill or downhill.
• Vehicle in front is partially visible on a
crossroad or curved road.
• There is a traffic light, reflecting sign,
flashing sign or mirror ahead.
• There is a temporary reflector or flash
ahead (construction area).
• The road conditions are bad such as
being wet, iced or covered with snow.
• A vehicle suddenly appears from a
curve.
• The vehicle is tilted from a flat tire or
is being towed.
• Light from a oncoming or front vehicle
is not detected due to obstacles in the
air such as exhaust fume, smoke, fog,
snow, or water spay or blizzard on the
road, or fogging in the lamp, etc.
Information
For more details on the limitations of the
Front View Camera, refer to “Forward
Collision-Avoidance Assist (FCA)” section
in chapter 7.
WARNING
• At times, High Beam Assist may not
work properly. High Beam Assist is
for your convenience only. It is the
responsibility of the driver for safe
driving practices and always check
the road conditions for your safety.
• When High Beam Assist does
not operate normally, change
the headlamp position manually
between high beam and low beam.