6-21
06
Using i-PEDAL
i-PEDAL assists the driver to accelerate,
decelerate, and stop the vehicle with
only the accelerator pedal.
Turning on/off the i-PEDAL
• Turning on i-PEDAL:
Pull the left paddle shift lever (
)
once when the regenerative braking
level is at 3. i-PEDAL is turned on and
the instrument cluster displays the
‘i-PEDAL’ message. i-PEDAL is not
available while the smart recuperation
system is ON. Turn off the smart
recuperation system first before using
i-PEDAL.
• Turning off i-PEDAL:
Pull the right paddle shift lever
(
) once while the function is ON.
Otherwise, shift the gear to R (reverse)
then to D (drive) while the function
is ON. i-PEDAL is disabled and
regenerative braking level is set to 3.
CAUTION
• Depending on the vehicle and road
condition, the vehicle may not come
to a stop although the i-PEDAL
function is active. Check for the
surroundings and depress the brake
pedal to control the vehicle speed.
• Do not use i-PEDAL on slippery roads.
i-PEDAL limitations
In the following conditions, the vehicle
may not come to a stop although the
i-PEDAL is properly activated. Depress
the brake to stop the vehicle.
- When driving on a slope, or when
the vehicle is repeatedly driven and
stopped
- When the vehicle is driving through
the end of the slope
- When driving on a slippery surface
such as an icy, rainy, or muddy road
- When the wheels are not properly
aligned
- When a wheel slip or wheel spin
occurs
- When the weight on board is too
heavy
- When the vehicle is tilted to the side
- When the tire is worn out too much
To Next Page
Loading...
