7-42
Driver assistance system
Blind-Spot Collision-Avoidance
Assist disabled
OJKEV072230LOJKEV072230L
When the rear bumper around the rear
corner radar or sensor is covered with
foreign material, such as snow or rain,
or installing a trailer or carrier, it can
reduce the detecting performance and
temporarily limit or disable Blind-Spot
Collision-Avoidance Assist.
If this occurs, the ‘Blind-spot safety
system(s) disabled. Radar blocked’
warning message will appear on the
cluster.
Blind-Spot Collision-Avoidance Assist
will operate properly when such foreign
material or trailer, etc., is removed, and
then the vehicle is restarted.
If Blind-Spot Collision-Avoidance
Assist does not operate properly after
it is removed, we recommend that the
vehicle be inspected by an authorized
retailer of Genesis Branded products.
•
•
with foreign material right after the
Limitations of Blind-Spot Collision-
Avoidance Assist
Blind-Spot Collision-Avoidance Assist
may not operate properly, or it may
operate unexpectedly under the
following circumstances:
• There is inclement weather, such as
heavy snow, heavy rain, etc.
• The detecting sensor is covered with
snow, rain, dirt, etc.
• The temperature around the
detecting sensor is high or low due to
surrounding environment.
• The detecting sensor is blocked while
driving near a vehicle, pillar, or wall.
• Driving on a highway (or motorway)
ramp or driving through a tollgate.
To Next Page
Loading...
