1-48
Foreword/Starting your electric vehicle
OJKEVQ011071OJKEVQ011071
• Leakage current failure (POWER Green
ON, FAULT Red Blink)
• After disconnecting and reconnecting
the power plug, press and release the
button for 2 seconds or longer to clear
the error.
We recommend that you contact an
authorized retailer of Genesis Branded
products.
OJKEVQ011072OJKEVQ011072
Power saving mode
• 7-segment display is turned off if there
is no status change for more than 1
minute.
How to Disconnect Portable Charger
(ICCB: In-Cable Control Box)
OJKEVQ011050OJKEVQ011050
1. Press release button (1), then remove
charging connector from the vehicle
inlet.
Information
To prevent charging cable theft,
the charging connector cannot be
disconnected from the inlet when the
doors are locked or the charging connector
is in the ‘Locking while charging’ mode.
Unlock all doors to disconnect the
charging connector from the inlet.
However, if the vehicle is in the charging
connector ‘Always lock’ mode, the
charging connector automatically unlocks
from the inlet when charging is completed.
If you attempt to disconnect the charging
connector without pressing the release
button, the connector and the inlet may be
damaged.
For more details, refer to “Charging
Connector ‘Always lock’/‘Locking while
charging’ Mode” in this chapter.
If the release button does not work even
after the all doors are unlocked, pull
the emergency lift cable in the motor
room and press the release button in the
connector to disconnect it from the vehicle.
If the release button still does not work,
we recommend to consult an authorized
retailer of Genesis Branded products.
To Next Page
Loading...
