9-50
Maintenance
Headlamp low beam
Based on 10m screenBased on 10m screen
OJK090047LOJK090047L
[1]: Vertical line of the left headlamp bulb center
[2]: Car axis
[3]: Vertical line of the right headlamp bulb center
[4]: Horizontal line of headlamp bulb center
[5]: cut-off line of left headlamp
[6]: cut-off elbow of left headlamp
[7]
: distance between vertical line and cut-off elbow of left headlamp → 38mm
[8]: cut-off line of right headlamp
[9]: cut-off elbow of right headlamp
[10]
: distance between vertical line and cut-off elbow of right headlamp → 38mm
[11]: 130
[12]: W1 (Low beam)
[13]: H1 (High beam)
[14]: Ground
1. Turn the low beam on without driver aboard.
2. Before aiming the car, hide the inner module of each side head lamps.
3. The cut-off line should be projected in the cut-off line show in the picture.
4. When aiming the low beam, vertical aiming should be adjusted after adjusting the
horizontal aiming.
5. If headlamp leveling device is equipped, adjust the headlamp leveling device switch
t o “o ”.
à The high beam is aimed simultaneously when aiming the low beam.
To Next Page
Loading...
