2-3
Maintenance
To clean the platen and the bail rollers:
1. Apply a small amount of alcohol or water to a soft cloth. Avoid spilling alcohol or
water inside the printer.
2. Place the cloth against the platen and manually rotate the platen knob.
3. To dry the platen, place a dry cloth against the platen and manually rotate the platen
knob.
4. Gently wipe the paper bail rollers using the cloth moistened with alcohol or water. Dry
the rollers using a dry cloth.
Cleaning the Print Head
If the paper is smudged or stained by ink, clean the nose of the print head with a dry cloth.
For removing and installing the print head, see the section, “Replacing the Print Head,”
later in this chapter.
Replacing the Ribbon Cartridge
If printing is too light because of ribbon wear, replace the ribbon cartridge. Appendix A
lists the order number for the ribbon cartridge.
The replacement is almost the same with the installation except that it involves removing
the old ribbon cartridge and unpacking the purchased ribbon cartridge from the carton.
To Next Page
Loading...
