1-1
1
Introduction
The information provided in this guide applies both to the GENICOM Matrix Printer
LA36N (80-column printer) and to the GENICOM Matrix Printer LA36W (136-column
printer). However, illustrations are of the LA36N Printer.
Your new LA36 printer is easy to install and set up. Just follow the step-by-step procedures
contained in this part to set up the printer and starting printing right away. If this is your
first printer, you should read the entire part before attempting to use the printer.
GENICOM MATRIX PRINTER LA36 TABLE OF CONTENTS:
Chapter 1 Introduction 1-1
Step 1 - Selecting a Good Location for the Printer 1-2
Step 2 - Unpacking the Printer 1-3
Step 3 - Assembling the Printer 1-5
Step 4 - Connecting the Power Cord 1-12
Step 5 - Testing the printer before connecting it to your host system 1-14
Step 6 - Connecting the printer to your host system, including
selecting a protocol and a printer driver, and printing
a test page from your host system 1-17
Chapter 2 Maintenance 2-1
Chapter 3 Troubleshooting 3-1
Appendix A Supplies and Options A-1
Appendix B Technical Support B-1
Appendix C Software and Documentation CD-ROM C-1
If you have any problems while setting up the printer, review the section, "Trouble-
Shooting," in Chapter 3 of this guide. If the problem persists, contact your dealer.
To Next Page
Loading...
