Genie GCL-MJ User Manual

Sec-4.11
Operator Cycle Count
Section 4: Programming
1. Press CAL/RUN to enter CALIBRATION MODE.
2. Press SCROLL until display reads CYCLES>1,2,3 etc. where the number shown is the number of open/
close cycles the operator has performed. FIG. 7.
3. Press CAL/RUN to return to RUN mode.
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
CYCLES 1
FIG. 7

Genie GCL-MJ Specifications

General

Brand	Genie
Model	GCL-MJ
Category	Garage Door Opener
Language	English