MPS2000
13
Press either [◀]
SELECT
or
SELECT
[▶] button to find out name parameter.
Press either [◀]
DATA
or
DATA
[▶] button to find out the letter.
If a letter appears in the cursor position, press the [
RECORD
] button to fix it and move to the next letter.
Another way to add input is by pressing the appropriate key as the chart below.
Press the key that matches the letter. Refer to the chart, press the [
RECORD
] button to fix it and move
to the next letter.
Repeat the procedure as above.
If the new name is completed, then press the [◀]
SELECT
and the
SELECT
[▶] buttons together to
finish.
How to change the User-set name
To Next Page
Loading...