BRAIN 17 4 732788 - Rev. A_1
ENGLISH
INDEX
CE DECLARATION OF CONFORMITY .....................................................................................2
WARNINGS FOR THE INSTALLER ...........................................................................................3
1. TECHNICAL SPECIFICATIONS ............................................................................................5
2. PREPARING FOR INSTALLATION .......................................................................................6
3. BOARD LAYOUT ...................................................................................................................6
4. ELECTRICAL CONNECTIONS .............................................................................................8
4.1 J1 - MAINS PRIMARY POWER SUPPLY .........................................................................8
4.2 J2 - MOTORS AND FLASHING LAMP .............................................................................8
4.3 J3 - LOW-VOLTAGE ACCESSORIES - INPUTS/OUTPUTS ............................................9
4.4 J12 - PROGRAMMABLE OUTPUTS - ELECTRIC LOCKS .............................................10
4.5 J12 -J6 - LIMIT SWITCH AND TIMECODER ....................................................................10
4.6 J10 - BUS G-WAY ACCESSORIES .................................................................................11
4.7 J5 - RQFZ MODULE RAPID CONNECTOR ............................................................................ 14
4.8 TRADITIONAL PHOTOCELLS .........................................................................................15
5. PROGRAMMING ...................................................................................................................18
5.1 BASIC PROGRAMMING FUNCTIONS .............................................................................19
5.2 ADVANCED PROGRAMMING FUNCTIONS ....................................................................24
5.3 BUS G-WAY DEVICE INSTALLATION .............................................................................27
5.3.1 BUS G-WAY DEVICE ENTRY .......................................................................................27
5.4 TIME LEARNING - SETUP ................................................................................................29
5.5 TESTING THE AUTOMATED SYSTEM ............................................................................30
6. MEMORISING THE RADIO CODE ........................................................................................31
6.1 MEMORISING THE JLC RADIO CONTROLS ..................................................................31
6.2 MEMORISING RC RADIO CONTROLS (ONLY 433 MHZ) ...............................................32
6.2.1 REMOTE MEMORISATION OF
RC RADIO CONTROLS .........................................33
6.3 DELETING THE RADIO CONTROLS ...............................................................................33
7. START-UP ..............................................................................................................................34
7.1 CHECKING THE LEDs ......................................................................................................34
8. SIGNALLING ERRORS AND ALARMS ................................................................................35
8.1 ERRORS ............................................................................................................................35
8.2 ALARMS ............................................................................................................................36
9. TROUBLESHOOTING ...........................................................................................................36
10. MANAGING THE CONFIGURATION FILE – J8 USB .......................................................37
11. FUNCTION LOGICS ............................................................................................................40
To Next Page
Loading...
